Worse case for your yours is to throw in a built motor.

Thanks gents. Actually I read about wrapping a chain around the broken bits and hooking the puller into that, so might give that a go before I start cutting the jaws. If I do end up cutting the pulley and it falls in the sump, we will both have clunks going over speed jumps but for different reasons.

Nice work on the Integra

$45 Amazon bearing separator kit FTW

Attempt 1 must have at least got it moving as it pulled off real quick just using a ratchet spanner

Went to fit that Raceworks push in breather adaptor but wouldn't fit - presumably due to my double powder coating.

So I just pushed the hose into the port on the cover and wondered why I didn't just do that the first time...

that's a fairly agricultural fix lol, just poke the hose in the hole.

I could add the factory clamp, but it is nice and snug and will just be annoying when I remove the coil cover.

Next time the rocker cover is off I might buzz it back and install the fittings.

Rear shocks arrived for my car today. I'll chuck them in when it's not raining.

Bit of momentum gathering to get her running again? 

Nah this is for the na beast. It has 367xxxkm so everything is worn out. Still cheaper to fix it as it needs it, than to rebuild the turbo car.

Ball joints are finally arriving today, what a farkup that was. Anyhow they are arriving this morning and it's pissing rain.

They sent the wrong ones...