08 Fg Xr6T Ute

[JETURBO]

Hahahahaha yeh something like that 

 

I think I just have more mechanical sympathy than most but yeh what's done is now done 

[camo86T]

Checked Eaton's site and felt better lol

 

Reckon it'd be well 'seated'  

[bossmang]

Dont lower the front ive got ssls (they look more like sssl) and the front is too fkn low even with the 20s

[camo86T]

What's your hub to guard measurement on the front freaky

No way I want to leave the front higher, looks *beep*.

I'll put the ssl's in, if it's a pain in the arse I'll probably swap them for sl's and try to hunt down some sl leaves.

I'm aware that std xr front springs are same / similar height to sl's but after 8 years of boating I want some tighter handling. 

[OZYWALKER]

Going by the pic I reckon you'd have to go around 320-330 mm hub to guard to get it sitting right. Your dump-cat flange will hate every speed hump.

[camo86T]

If I can get it level I'll be happy enough.

Have been thinking about modding the dump to lift it a bit higher regardless, haven't measured it but it sags low-ish...common with xforce from what I've read.

 

If I have to I'll knock up a set of rear shackles to give it say another 10-15mm height.

[bossmang]

im thinking of coilover fronts soon to get the height I want. 

 

ive got 4" x force and the bitch hangs so low scraps everything. stupid xforce. 

 

can get a measurement for you. pissing down rain atm so keep reminding me later if I forget 

[camo86T]

Yeah that'd be good if you can mate

 

Anything else that scrapes or mainly just the exhaust?

[bossmang]

front lip and then the lip right under the front bumper hangs lower again. 

 

already had a tow truck driver smash it off because he didnt think it needed the ramps . dumb ass was too lazy to get them out. 

 

I daily with 20s to give me some height ahahah

[camo86T]

Yeh the stone tray takes a hammering on these cars, torn the lip of it off my stock height G6ET ages ago 

 

See how I go