Jump to content

What Did You Do To Your Car Today?


Henz

Recommended Posts

  • billet turbos and weathered engines dont mix
  • Donating Members
  • Member For: 11y 11m 7d
  • Gender: Male
  • Location: Wollongong

how good does a decent brake setup look on a clean car!

Link to comment
Share on other sites

  • Bronze Donating Members
  • Member For: 12y 1m 24d
  • Gender: Male
  • Location: Newcastle

I spent a few hours polishing my car

Used menzerna polish, dodo Juice lime prime glaze and Wolf's Chemicals hard body sealant

I will post some better pictures of it out of the garage tomorrow

post-50206-138829725806_thumb.jpg

post-50206-138829728471_thumb.jpg

post-50206-138829730727_thumb.jpg

Link to comment
Share on other sites

  • Member
  • Member For: 11y 2m 3d
  • Gender: Male
  • Location: Perth
I spent a few hours polishing my car

Used menzerna polish, dodo Juice lime prime glaze and Wolf's Chemicals hard body sealant

I will post some better pictures of it out of the garage tomorrow

Nice. You like sealant better than wax? Do they look similar? Wax looks good but cbf doing it every 2 or 3 months.

Link to comment
Share on other sites

  • Manual mode ________________________ All day, erryday
  • Donating Members
  • Member For: 16y 5m 4d
  • Gender: Male
  • Location: Probably above atmospheric pressure

Wish I had paint to wax or seal.

  • Like 3
Link to comment
Share on other sites

  • Bronze Donating Members
  • Member For: 12y 1m 24d
  • Gender: Male
  • Location: Newcastle

It is the first time I have used a sealant instead of wax so I haven't made my mind up yet

It looks the same to me but if it lasts longer then I will definitely prefer it

Link to comment
Share on other sites

  • Manual mode ________________________ All day, erryday
  • Donating Members
  • Member For: 16y 5m 4d
  • Gender: Male
  • Location: Probably above atmospheric pressure

Cabin bling awwwwwwwwwww yeah!! Reversing one of the cost cuts from BA to BF.

20131230_132601.jpg

Before 20131230_134239.jpg After 20131230_134242.jpg

Also fitted the new cog and springs for my busted driver's door actuator the other day, forgot to spray lithium grease in there before reassembling...so had to pull it apart again to reduce the whirring noise the new cog seems to make when locking, but still much nicer being able to use remote central to lock the driver's door again.

Edited by -SteveR-
Link to comment
Share on other sites

  • Menace
  • Donating Members
  • Member For: 13y 7d
  • Gender: Male
  • Location: Sydney

Anyone know if this is enough movement from the actuator or if it looks about right?

I have set the actuator to fully close at 12lb yet I'm still over boosting.

Only real dif. is I've made the intake pipe about 300mm shorter, same size pipe.

  • Like 1
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'