Sa Members

[XR6TCamo]

I was thinking more september 25th??...ish anytime after that!!! october 2nd would be perfect! at least it gives everyone plenty of time to do more mods cause im sure once we have this cruise the next one wont be for AGESSSSS

[JETURBO]

In and around his mouth??

where the f*ck u been mr shaunny hows the car chuck up some pics of the beast

[JETURBO]

well we can definately make the dates whateva the crowd wants or on here the lack of crowd but yeh why not september 25th is good bloostie ya *beep* fire up a cruise thread my man

[sly100]

heaps of progress happenin lots of pics to come :D :D

btw f*ck circlips

I just dropped oil that's 1.5k old bit of a waste lol

hopefully my loctite paste will seal my oil feed line bolt etc etc

[JETURBO]

yeh dude chuck up pics always good to have a look see what others are doing

[Panda Eyes]

jet you are on fire tonight. either your bored or you hade too much red cordial...

[bloosted]

it's just the fluffer has taken the ping pong ball out of his mouth

[sly100]

gah wish I had my imperial spanners at the house my car is staying at.. stupid speed flow fittings making it tricky for me... hahah

chuck the progress pics up tomorrow... hopefully I dont get any leaks or im not gonna be happy.. im using loctite thread sealant so should be ok..

its a bit of stuffing around too... cant put my oil filter on until ive done up the fittings.. and I cant fill up the oil until ive put on the filter then I cant test the oil flow through the etm line..

cant put my turbo and manifold back on until ive tested the oil flow...

still gotta put the coolant back in and swap the spark plugs....

then finish wiring the gauges, put the fpv steering wheel in and put all the pipework back together

THEN off to MV automatics

should be keen for friday night laps in 2 weeks hopefully get a few people out

[sly100]

dropping lovely clean new oil haha

oil pressure sensor removed

oil feed line removed.. this was so full of caked sh*t im supprised it even flowed oil.

oil screen fitting removed from block

yummmm

snapped both the eyelets off the circlip what a sh*t job trying to remove half a circlip with a skewer lol

got it out in the end.. that filter is an absolute joke.. so blocked up and fine

etm filter

all clean ready to go back in

line temporarily mounted

sandwich plate

etm oil feed line attached to fitting

mmmm

looks brand spankers... :hiwelcome:

Edited 12/08/10 11:30 PM by sly100

[whyallapunk]

I'm from Whyalla and am looking for a repeutable tuner in Adelaide. Currently sitting at 302rwkw going for more. Any suggestions?