Search the Community
Showing results for tags 'fuse'.
Found 4 results
-
I'm dealing with an issue on my 2003 BA turbo manual where the fuel pump relay is not getting a trigger signal from the PCM. The car is tuned with an SCT flash tuner, but this was done years ago, this issue is only recent. The fuel pump does not get a signal from the PCM to prime or run. Sometimes disconnecting the battery and letting the PCM reset will fix it, sometimes it won't, but eventually it stops working and won't work again until reset. The fuel pump and all its wiring after the fuse box is fine, the car runs without issue if I bridge out the fuel pump relay with a jumper wire. I have swapped and tested multiple relays and changed the inertia switch, didn't fix it. The wires between the PCM and the fuel pump relay are fine (<1ohm), and all the PCM pins and connectors look fine, so I'm convinced the PCM isn't opening the ground signal to open the fuel pump relay (it does have 12v on the coil side). When it happens it throws code P0230 fuel pump relay primary circuit malfinction. Has anyone encountered this before and has any idea where to look next? Is my PCM dead? Any advice is appreciated, thanks
-
I own a 2007 bf xr6t, I was driving along when my car just turned off. Found the problem and it was a blown 30 amp fuse labelled “eng” but it keeps blowing and turning the car off while I’m driving every time I replace it. I have heard others say theirs is doing the same but apparently it happens after running the air con after about 20 mins. Whenever it blows the engine won’t crank and the starter doesn’t click it only cranks and turns on when I replace the fuse. Has anybody else had the same issue and know how to fix this problem? Cheers.
-
Hello all, here with the worst of all, an electrics problem.. (hopefully simple) I was out driving the ba turbo with my mate tonight who yesterday picked up his new ba turbo as well, so up to kings park Perth and back was simple enough. All was fine until I went to leave, and my tail lights, and fog lights wont turn on. Brake lights work, headlights and high beams work, indicators work, just no tail lights, or fog lights. Naturally once home I got out the manual and pulled tail lights fuse, and its fine. Pulled fog lights fuse in engine box, that's fine too. If it were just tail, or fogs I would be thinking the relay, but for both of them, to stop working at the same time with different relays confuses me? or just unlucky? any ideas, or into the shop....? Thanks!
-
hey guys so in my normal style I started off doing somthing I knew nothing about! its all apart of my style what I was doing was removing the icc so I could install some gauges I just jumped straight into it didnt bother to disconnect the battery rookie mistake! any how, half way thru the alarm starting going off and I figured it was time to disconnect the battery so I did, I finshed what I had to do and now when it came to starting my car it wouldnt start at all , I would turn the key to acc n all the lights were on but wouldnt start, the raido read "code error", and from what I have read it just takes half an hour or so to go back to normal as it is the origanal unit so no code is needed, but my issue now is the car wont do anything at all it dead nothing happens when the key is any position , Im thinking its prob fuses or relays, I relize I will have to take it some where but is there any trouble shooting tips you guys have befor I get it towed, just to make you all laught the sun roof is open n garage is full! im off to k-mart to by a garden shade haha... any help would be great!
