Show Us Ya Tips!

[kink]

What do we think is the max twin pipes that will fit the gap? I roughly measured the G6ET cutout at 8 inches, so I am thinking a tight fit for two 3.5s. Anyone got that?

[OZYWALKER]

Have seen twin 3.5, tight and didn't look right.
You'd want a bit of room as they will move around a bit and after a flogging the get pretty hot, the bumper will burn if it's too tight.

[kink]

Yea fair call.

 

I have lost the thread I found it in, but someone posted a photo of a hose clamp around a rubber hanger to raise a muffler a little, as mine is hanging way too low. 

[discostig]

Opposite problem on mine, would prefer it to sit a cm lower as it's right up near the bumper now and has some rub marks on it!

[skidxr6t]

I like how yours are tucked in Steve, so if someone reverses into you they hit bumper before the exhaust. mine stick out a bit. might upload a photo of it sometime.

 

id like a big tow hitch on the back of my car, feel safer with one for some reason.

Edited 28/11/16 05:06 AM by skidxr6t

[Panda Eyes]

I have twin 4". I like them.

 

bad photo. but:

[kink]

Goddamn do you have a pic?? [emoji44]

[Panda Eyes]

or they might be 3.5. ill measure.

[kink]

I like that look. How do they fit in the bumper? Do they hit at all?

[Panda Eyes]

nah all good- had to cut the bumper to shape on the left to accommodate the extra width.

 

they are on a twin 2.5 system.