Hoping For 600+Kw And 9Sec 1/4 Mile From My G6E

[JETFPV]

Any updates..??

[Adam]

Incorrect cam timing perhaps?

[xr6t_ute]

Its pretty strange especially when they run it up on the engine dyno before delivery.

[needfordspeed]

I'd probably look at the lifters as well, has happened to me before on a new motor.

Edited 18/08/11 01:27 PM by needfordspeed

[Henz]

He's started another thread, turned it over and there was zero compression cylinder 6.

[DUS12]

cant be cam timing if its only one cylinder, it will be a lifter, brad will give you excelent service mate, give him a call im sure he would happily talk to you

[Ralph Wiggum]

+1 for lifter.

I would have thought the average mechanic would start here if compression returned after removing the cams?

[AtomiCg6]

yehh motors gone bak to sydney today..

Not wat I needed

[xr6t_ute]

Dont stress youll still get the same outcome, and once its all going, youll forget about everything youve gone through.

[possum]

+1 for lifters, when I changed the valve springs in my old BA we took the lifters right out, needless to say it wouldn't run until they bled up properly, started to run on 3 then 4 then 5 until finally all 6