I've spaced the lining to 189mm

woo, success

I finished the left side now and it seems ok

The adjuster seems hard to get to with the rotor on

I had difficulty getting the new rotor to sit flush as well

Took it for a spin it seems ok

It's important to get the rotor to sit on the hub properly. It's too late now but you should have sanded the hub between the wheel studs to remove the rust

Hi mate, I used a wire wheel on the wheel itself and also on the hub. I tried to get rid of all the rust.

Thanks for everyone's replies and arronm's detailed replies with pics

The left side took about 2 hours to complete

The rotor came off quite easily

These rotors were from DBA slotted type as well

Whoever installed them put them the wrong way around I mean left to right

For the front I have remsa pads, I found with the 6 piston brembos, they didn't fade at Wakefield. I like these as street pads.

Next I'm going to put Bendix Ultimate in the front, followed by qfm zx2800.

good job on getting it sorted

I'll be doing rear rotors soon, so learned lots from this thread. Might give it all an overnight treatment with a few litres of wd40 first!