Guard Rolling Issue

[mikea1988]

Hey guys I need to have my rear guards rolled on my ba mkii.

Went to a local bloke uses the rolling tool however he noticed some filler having been rubbed on the inside of my right wheel arch. He said he can't use the rolling tool because the filler won't bend and the guard would just snap.

What are my options? Rims are slightly scrapping on big dips in the road so want this fixed especially for when it gets strapped down on a dyno again and it really squats.

Left side can be rolled just dont know what I can do for the right side with filler rubbed in the wheel arch.

Your help is greatly appreciated.

Edited 29/12/13 12:45 AM by mikea1988

[Pazzo]

What size rear rims you got?

[arronm]

Roll the LHS and see how that goes. If the rhs rubs bad it will need surgery and paint.

[mikea1988]

Will look sh*t with only one side rolled.

Plus they will both have to be done before it gets on a dyno.

Rear rims are 20 x 10

Panel shop my only option?

[Pazzo]

Run a 245 35 20 rear tyre with stretch.

[mikea1988]

Tyres are pretty much new. Didn't want to spend 5-600 bucks on new tyres again.

They really should be rolled.

[Panda Eyes]

paint shop- new guard welded in- painted- rolled.

[Henz]

2 new cheap tyres = $300.

Guards rolled and painted by a panel shop could run upto $1k by the time both sides are blended.

Dyno it on 17s.

[sexual harrassment panda]

^^^^^^^^^^^^^^^^^^^^^^^^^

THIS

[mikea1988]

So you think different tyres even though the width is 10 inches would avoid any rubbing?