Need to roll the guards on the BA and was wondering how hard it is to do with the rolling tool any tips would be great

Edited March 5, 201214 yr by TURBO4LT

dont forget your heat gun and temperature light gun thingo.

good luck

Use a heat gun and the correct guard rolling tool or this happens.

http://youtu.be/1LdDAa6TNWE

yes this /\ ive seen this done on a Late model camira on the rear with a round bar and it actually worked very well ............................but dont try it

Get the proper tool and a heat gun, not that dear to buy. Then just go slow. The tool is good

For pumping too.

Unless you some experience, then doing it the old school way still works well.

I did mine, had on hand a heat gun, guard roller and rubber mallet.

I found the roller was hard to get started with the angle of the lip, so used the mallet to start it off.

Then used the roller, after a certain point it was just trying to pump the guard out and wouldn't fold anymore, so I gave it some more love with the mallet.

Had no problems with paint cracking.

Its not that hard, I bought my own roller. I have done about ten cars now. Its just technique and making sure yet get the paint nice and hot. Don't rush take lots of small steps. If you're not sure just get a professional to do it as you can easily f_uck it up.

Thanks for the info guys Ill give it a go and see how it goes.

I use a heat gun, panel hammer and dolly.

go easy on the heat gun though, and dont hold it too farkin close, to speed up the heating process. keep it back abit if using high heat.