Custom Exhaust

[Ninka]

Just thought I would post some information about my latest mod, which is a custom made 2 x 1/2" mandrel bent stainless steel system.

Exhaust configuration is: SMB 4" dump pipe, SMB 5" cat, 2 x 2 1/2" mandrel bent cat back system ending in 4 x 2 1/2" stainless tips.

System was built by APC in Myaree, and they have been fantastic, as I was unhappy with the sound (drone) of the first attempt, and they have come to the part and changed the rear mufflers and reduced the size of the tips, all with absolutely no fuss.

I will try to get photos on the weekend

[Adrian6T]

Well done Al.

You love it dont you.

Cheers

Adrian

[jordak]

You are having fun aren't you

[Ninka]

You are having fun aren't you

←

Well one can but try

[F6 UTE]

You would have thought they (APC ) might have learnt from when Greg did his quads there ( wangarra ). It too droned, and they had to change the mufflers. Don't these people talk to each other??

Edited 29/09/06 05:23 AM by F6 UTE

[Ninka]

You would have thought they (APC ) might have learnt from when Greg did his quads there ( wangarra ). It too droned, and they had to change the mufflers. Don't these people talk to each other??

←

Apparently not

This is especially critical in an auto, as the rev range is narrower than a manual during normal driving.

[Ninka]

Well, finall got my act together and took some photos as promised

[Guest]

You've done pretty much what I've discussed with APC in Wangara. Initially I'm just going to do the twin pipes with quad tips and then progress from there

I am a bit reluctant because I don't want a horrible drone but they've assured me that this won't be the case yet I am reading that apparently this has happened in the past.

Hope yours is just what you were after. Sounds like it.

[Adrian6T]

Nice mosquitos under yours guards I see.

Looks good

[YPURV4]

To many mufflers