Should be able to stretch to a 3+

How much would it cost for install roughly, any idea?

Call Simon and get a quote

Did they check your tint with some sort of light meter or did they just guess it maybe to dark , the way they guess the cars to low, or the exhaust is to loud. Or your tyres are to wide. Cops, mate what can I say. Iam sick of them making stuff up.

It does not matter to a copper. They only have to SUSPECT a problem to make you get your car checked at an inspection pit.

go the 3+ ... ive done 55,000 hard KMs in my xr8 since getting that clutch, and it has never failed me.

as for rims, I wouldnt purchase wheels in WA, except for JPC ... but if I could, id buy from eastern states or overseas, as Perth wheel/tyre companies are ripoffs!

Anyone installed a tail shaft loop on their BA/BF/FG sedan before? If so where do you have to place it? Need a definite answer by next Monday

Edited April 18, 201115 yr by XF Falcon

Spoke with West Racing Motor Development today, quoted $2300 for 3+ and fitment. Do you think $500 is reasonable for the install?

Also spotted a white R-spec today on south st / stock rd intersection. Had SA plates.

Also, this is the car that is always parked across the road from my work (mentioned in previous post):

Edited April 18, 201115 yr by CyanideIllusions

$500 is average. Should be able too knock it out in 2 to 3 hrs on a hoist.

I can do it in 3.5/4hrs on the floor with a jack so anybody with a hoist and trans jack, and air tools @ hand should be a fair bit quicker!

I´d ring Simon @ XFT he replaced more clutched than he can probably recall

Altezza's on an R-Spec...oh well, "to each their own".

Anyone installed a tail shaft loop on their BA/BF/FG sedan before? If so where do you have to place it? Need a definite answer by next Monday

Told ya already

go the 3+ ... ive done 55,000 hard KMs in my xr8 since getting that clutch, and it has never failed me.

When you run bugger all ponys they will last forever.

Spoke with West Racing Motor Development today, quoted $2300 for 3+ and fitment. Do you think $500 is reasonable for the install?

Its in the ball park. Call Simon and see if he will do it cheaper

Dont forget to put in a malwood remote clutch bleeder while the box is out.

Edited April 18, 201115 yr by arronm