KevXR6 New Member 2 Member For: 4y 7d Posted 20/04/20 06:37 AM Share Posted 20/04/20 06:37 AM (edited) Hi all  Simple question for you all to start with; How do you remove and replace the cigarette lighter in 2009 XR6 ute? I can find no instructions on how to pull the the console out to get to the back of the lighter. I have seen comments about "how easy it is" but no actual instructions 😞  Second question, not so simple; I have an issue, electrical in nature. If I have my foot on the brake when the car starts I hear audible alarms (beeping) and get errors messages in the dash saying "headlight fault" and the some lights and symbols flash in the dash and the screen on the ICC also flashes. I replaced the brake switch (this was suggested as a possible fix, it didn't work :() any suggestions before I take to auto electrician and spend hundreds of $$$ for him to say "oh this $3 switch was rooted" Edited 20/04/20 06:39 AM by KevXR6 Link to comment Share on other sites More sharing options...
KevXR6 New Member 2 Member For: 4y 7d Posted 26/04/20 08:30 AM Author Share Posted 26/04/20 08:30 AM (edited) what  a complete  waste of time this forum this Edited 26/04/20 08:31 AM by KevXR6 Link to comment Share on other sites More sharing options...
espoig Donating Members 249 Member For: 9y 7m 22d Gender: Male Location: Mundaring Posted 26/04/20 09:45 AM Share Posted 26/04/20 09:45 AM Lift up the lid on the center console and pull from the back there, the whole piece will slowly unclip with a bit of force then just pull the tissue holder out under the icc, its only held on by a couple of clips Link to comment Share on other sites More sharing options...
arronm Dropping a turd Gold Donating Members 9,520 Member For: 16y 6m Gender: Male Location: Perth Posted 26/04/20 11:53 AM Share Posted 26/04/20 11:53 AM 3 hours ago, KevXR6 said: what  a complete  waste of time this forum this  Do you think answers are expected and free. Link to comment Share on other sites More sharing options...
Tom Tucker Donating Members 615 Member For: 4y 9m 28d Posted 27/04/20 03:29 AM Share Posted 27/04/20 03:29 AM That's kinda the idea of enthusiasts forums, within reason... It's meant to be about friendly people helping one another out over a shared interests... Link to comment Share on other sites More sharing options...
Mrs Jeturbo Bob the Freaking Builder Donating Members 10,805 Member For: 14y 7m 14d Gender: Female Location: SA Posted 27/04/20 03:36 AM Share Posted 27/04/20 03:36 AM He was being sarcastic. Â Also since OP is obviously a rude little turd... it's good he got f all answers. 2 Link to comment Share on other sites More sharing options...
espoig Donating Members 249 Member For: 9y 7m 22d Gender: Male Location: Mundaring Posted 27/04/20 05:32 AM Share Posted 27/04/20 05:32 AM But honestly if you can't figure how to take the centre trim out, you really shouldn't be working on your car 😂 2 1 Link to comment Share on other sites More sharing options...
El Andrew Gold Donating Members 2,019 Member For: 9y 5d Gender: Male Location: Canberra ACT Posted 27/04/20 10:10 AM Share Posted 27/04/20 10:10 AM I remember seeingg this video once. Is a sedan but should give you the idea.We were all born not knowing which end to hold the screwdriver and had to start somewhere.But whinging about not getting an answer is not going to get you any friends. If you hang around here long enough you'll find there's plenty of people wanting to help if you are willing to give and take. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now