I bet you that when the heat gets out of the cable, it'll start fine.

It's parked in a 3 hour bay thankfully so I have until 11 to get it. If it doesn't start at 11, I'll get another ticket and have until 1.30, which is when I finish work.

Time has come, need new brakes. Ford Genuine quoted me like 3k, l0l. Ideas/opinions on good disc/pad combinations? Don't want to be spending an arm and a leg.

Have read a thread on here somewhere about options for aftermarket discs for Brembos , check out brakes section probably in there.

Matt @ RaceBrakesSydney Grug.

I run DBA4000series rotors and QFM pads. They work well and low dust compared to standard brembo pads

Have used QFM as my last set and liked them, decent performance, low dust. Think these Remsas bite better but they are a fair bit dustier.

+1 Matt at Race Brakes Sydney

I have the DBA5000 Rotors front and 4000 at the rear.

I usually use the Ferodo DS2500 pads and they work quite well. I currently have a set of QFM A1RM pads to go on next after hearing good things.

Ah yes I used the street friendly HPX pads from QFM, A1RM more high performing pads.

Matt @ RaceBrakesSydney Grug.

I run DBA4000series rotors and QFM pads. They work well and low dust compared to standard brembo pads

What cost would I be looking at?

DS2500 has been great for me. Not a fan of QFM since I got a set where the surface area of the material was less than stock.

What cost would I be looking at?

Not to sure mate but when I looked around a while back it was cheaper from him by a long shot and that included delivery.