Hardy Spicer FG Tailshaft Center Bearings

[AzSilverBullet]

So there is 4 different ones for FG. I am hoping I can find out which one I need before I pull mine out. 

My car is a 2008 FG XR6 turbo sedan auto. Does anybody know if my particular model runs a certain one or could it be any of the 4?

There is -

30mm inside diameter with 11mm or 25mm offset or

35mm inside diameter with 11mm or 25mm offset.

Edited 20/06/17 11:27 PM by AzSilverBullet

[Puffwagon]

I got under my car and measured. It only takes 5 minutes.

[k31th]

or speak to Hardy Spicer and tell them your specific make/model/trans setup and they'll be able to tell you which specific one will fit.

[Puffwagon]

That would work as well.

[AzSilverBullet]

It looks like it would be hard to get a accurate measurement of inside diameter while the bearing is on car.

How did you do it?

[k31th]

vernier caliper.

[Puffwagon]

Yep that's what I used.

[Ralph Wiggum]

1 hour ago, AzSilverBullet said:

It looks like it would be hard to get a accurate measurement of inside diameter while the bearing is on car.

How did you do it? 

If the car has a uni midship its 30mm ID

 

If it has a cv midship 35mm ID

 

Of all the variants of Ford driveshafts this doesn't change.

[AzSilverBullet]

Ok so what about offset bearing height? Maybe it depends on auto or manual for 11mm or 25mm?

[Ralph Wiggum]

the bearing height is the same, manual car get a spacer between the bearing mount and chassis, auto's do not.

 

What bearing are you looking at?