Nizpro Exhaust

[DUS12]

got it made here in townsville,

[Buf-Phoon]

Nice skid mate

[Wenier]

If they are emission testing any tuned car should pass as it wouldnt be running as rich as the factory tune. Or am I way off on your EPA stuff.

A scientest over here in NZ said cats are a waste of time and if everyone one just tuned and maintained their cars it would be better for the environment, so he's all for tuned cars.

[STAINLESS again plz]

does anyone know if u can buy the mufflers on this 4 inch system seperate

that's a negative. I asked same question.

Edited 23/06/11 12:14 AM by STAINLESS

[spoolxr6]

If they are emission testing any tuned car should pass as it wouldnt be running as rich as the factory tune. Or am I way off on your EPA stuff.

A scientest over here in NZ said cats are a waste of time and if everyone one just tuned and maintained their cars it would be better for the environment, so he's all for tuned cars.

Without a cat you cannot convert some of the poisonous gases into safe levels no matter how good your ignition timing and fuel trims are.

[ratter]

because a car might run leaner than another car does not make it cleaner emission wise

[Buf-Phoon]

If they are emission testing any tuned car should pass as it wouldnt be running as rich as the factory tune. Or am I way off on your EPA stuff.

A scientest over here in NZ said cats are a waste of time and if everyone one just tuned and maintained their cars it would be better for the environment, so he's all for tuned cars.

A price on carbon anyone

[Banned1]

A price on carbon anyone

the price will be "bend over "

carbon is not emmission based (the lies from the start ) and now , last night on APA, carbon EMMISSION trading programme with NZ ......lying bastids.

enjoy yer big bores while you can ! euro/jap hybrids and mega efficient HDI common rails will take over here like europe!!!

Edited 23/06/11 12:51 AM by rab

[bcl]

The Nizpro system is cheaper than going and getting a full custom 4" made up so I don't know what all the crying about the price is over? It is also cheaper than SMB, Manta and Tunehouses just to name a few.

It should be much cheaper ... lower quality Chinese made. Just compare the welding on the different systems and you'll note the difference.

If you're happy with it that's ok.

Brian

[spoolxr6]

I have compared the welds. They are clean steady tig welds, better than what I have seen on custom jobs from most exhaust shops. Also the stainless tube used is thicker than XFORCE. Anyhow is that how you rate an exhaust system by its welds? How about the twin 100cpi 4" body cats that can outflow any single unit, or the large bodied straight through 4" mufflers that keep the system quiet whilst not restricting flow? I admit it was a little fidly to fit but I can throw any kw's at it without a problem. Fact that it is made in China to keep to cost down, well I'm used to that considering about 90% of the goods on the market are now produced there. Here is a pic I'm no boiler maker but nothing wrong with the look of the welds to me??