Breaking News...nsw Rta Approval Required To Lower Car At All After A

[iTec]

I swear the next f*ckin politician that uses the word "hoon" in any sentence I am personaly going to track down and bitch slap

[NB4C]

Does lowering your XR6T actually provide any noticeable improvement in performance/stability/handling ? I always thought it was purely cosmetic.

Edited 16/07/09 04:22 AM by NB4C

[azasturbo]

Oh well I guess this is the motivation I need to rip out the 4 inch lifted springs from my truck replace em with 2.5s and just cut the crap out of the guards to make it all fit

[our06t]

it's only for cars done after the 1st isn't it they can't expect people to change things they have already done .

yours is a purpose built off roader not like the shopping trolley's I see around here 12 inches of body roll every time they go round a corner

and NB4C it seems to be around the 350 hub to wheel arch that is the best for these and that is only lowering 20ml so yeh I don't think a T dropped 50mm is going to handle better ,all for looks but that's what some people like and it's their car

Edited 16/07/09 04:26 AM by our06t

[Erko]

Does lowering your XR6T actually provide any noticeable improvement in performance/stability/handling ? I always thought it was purely cosmetic.

a slight lowering say to 350mm hub/guard will assist a bit by lowering centre of gravity.....however coupled with heavier spring rates then you are getting somewhere.

[NB4C]

Great info, guys. Considering that some Aussie roads will ground scrape most stock cars, lowering isn't for me.

[senna_T]

Great timing A-holes....

[tab]

Oh yeah

[our06t]

be ineresting to know where they mesure this from , because if it is just from under car height , if you had a set of 20;s on the car you could probably still drop it 3 inches and only be 2 1/2 lower than stock

[sixfan]

Oh ffs.

Edited 17/07/09 11:23 PM by sixfan