apexr6 Legacy Donating Member 65 Member For: 14y 7m 10d Gender: Male Location: Sydney Posted 06/04/12 05:48 AM Posted 06/04/12 05:48 AM ok everyone is going to jump on me for this but what ever! to be honest most the xr6t I hear sound pretty crappy compared to V8's that have the deep grunt where as any 6 turbo or not just doesnt have it...my exhaust is loud sounds ok but im into the induction n turbo sound! I have twin 3inch stainless system Im with you, the sound of a six will NEVER sound near as good as a lumpy v8 with exctactors and twin exhaust dumped at the diff. But the sound of the turbo spooling is something else. For me, only nessessery exhaust mods for power gains. 1
Colin 98 Member 2 Member For: 14y 8m 11d Posted 14/04/12 08:47 AM Posted 14/04/12 08:47 AM (edited) Is ther anything to be gained by fitting a BF-T or FG-T exhaust onto a BA-T (If I were to get a good s/hand one)? (I have no other mods done at this stage) Edited 14/04/12 08:53 AM by Colin 98
Ciaran Thooperrrrrrr Legacy Donating Member 2,768 Member For: 15y 2m 23d Gender: Male Location: NOR, Western Australia Posted 14/04/12 08:59 AM Posted 14/04/12 08:59 AM An extra O2 sensor?
shaunjennifer21 Member 95 Member For: 15y 2m 22d Posted 26/04/12 01:40 PM Posted 26/04/12 01:40 PM So what was the conclusion here ? I'm in the same boat I think I'm going to get a 4 inch dump with a high flow cat off ebay , then to either the twin xforce 2.5 cat back system or single 3.5 inch xforce cat back system
bradles024 Legacy Donating Member 1,145 Member For: 16y 10m 11d Gender: Male Posted 26/04/12 08:19 PM Posted 26/04/12 08:19 PM Bigjohn fromFalcon xr6t forums has a video on YouTube of a rapid exhaust, sounds ok fairly quiet.
wa g6et Member 657 Member For: 15y 3m 22d Gender: Male Location: Perth NOR Posted 26/04/12 10:41 PM Posted 26/04/12 10:41 PM I have the Xforce 3.5" system on my FG, Nice and quiet really, slightly louder burble at idle, cruising hardly noticeable(does get louder under load) but comes to life when pushed. Will say though it is difficult to get the system straight especially over the diff cradle because I have stainless it expands heaps and knocks slighly over the diff when idling(cannot hear when driving must move away when loaded from engine torque).The Xforce system is good value for money but if I had my time again I would go 4" stainless dump/cat section into a 3.5" mild steel cat back.
shaunjennifer21 Member 95 Member For: 15y 2m 22d Posted 29/04/12 12:29 PM Posted 29/04/12 12:29 PM whats the stock exhaust size on a 04 xr6 turbo ?
shaunjennifer21 Member 95 Member For: 15y 2m 22d Posted 29/04/12 01:52 PM Posted 29/04/12 01:52 PM Atm I can't afford a full exhaust sustem so I'm going to get the dump and cat pipe combo off eBay for 875$ and fit it up to the standard exhaust. What is the max power that exhaust set up will be able to handle ? Also not sure of it matters that much big the rear muffler has been replaced with just a strait through pipe (not by me by previous owner) only owned car for a month.
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now