hey guys,

does anybody know the minimum thickness of a brembo 4pot front rotor on the BF series phoons?

Cheers.

Mate , whilst I cannot answer your question do not get them replaced at Fraud.

I bled from the eyes just looking at the quote. $2500 oh and add GST to that

oh sh*t no I dont do ANYTHING thru ford unless I absolutely have to.

ive already got a spare set of front rotors, with a tiny lip on them, so I just wanna know min thickness so I can get them machined and hope their meaty enough! Gunna be running some racebrake RB24 pads on them.

I must say my brakes arent that great for brembo's but then again they have massive lipped rotors, and the pads are rooted!

Cant wait to get the new rotors and pads on to see how she hauls to a stop.

they should have it stamped on the rotor somewhere

Nathan, I highly recommend Bendix Street Road Track pads.

They have had an absolute pasting.I also run RBA slotteds on the front,

Can't fault either.. far better than factory IMO.Managed to crack the stockers

they should have it stamped on the rotor somewhere

checked them both, seems their not stamped

Buf,

if their anything like bendix ultimates I wouldnt touch them with a 40ft pole! They work well, squeel like mad and dust the rims out in 2 days

Obviously , I am not trying hard enough

Dusty as fark . granted bt they will pull you up quicker than the factory poo poo

checked them both, seems their not stamped

Is it on the outer lip of the rotor... You can always check and see if it's on your spare ones...

checked the spare rotors, ill rip the front wheel off later and have a geezer at them ones.

may aswell spend hafla on the ol girl, gotta chop the rear bump stops down a little too.