Factory Amp

[Dagabond]

The hole where the amp goes in the boot...

[XRSics]

top left side of boot (in premium models) dunnobout standard

if fitting one from normal sound package, id just locate it somewhere else

and get as big as u need

[smicky]

There is plenty of room in the boot housing (hole as dags referred to) to fit a larger amp if needed.

Some support rails may need to be cut and fitted, however not a hard thing to do at all!

If your not sure, best to get your local car audio shop to give you hand I would think mate.

If you have Premo sound the amp is located behind the 'boot lining' where the others have mentioned...

Edited 01/01/09 05:44 AM by smicky

[kodaz]

Is it the same place in an FG G6ET?

[PHANTMXR6]

All FG sedans with premium sound have the amp mounted in the l/h side of the boot behind the trim panel.

So yes, kodaz, it is there.

[Dillz]

Dude don't bother, I almost went down that road. You won't find a big enough good enough multi channel amp that fits where the factory one goes.

Sure you could get a small mono to run just the sub but then the rear speakers will crack the sh*ts and probably tell to stick the whole thing up your

Hope that helps a bit.

[kodaz]

All FG sedans with premium sound have the amp mounted in the l/h side of the boot behind the trim panel.

So yes, kodaz, it is there.

Thanks, will certianly make wiring the audiocontrol lc6 much easier.

[B-1B]

kodaz, that is the spot where I mounted my LC6.

I mounted the both amps on the sub box.

[bentles]

Dude don't bother, I almost went down that road. You won't find a big enough good enough multi channel amp that fits where the factory one goes.

Sure you could get a small mono to run just the sub but then the rear speakers will crack the sh*ts and probably tell to stick the whole thing up your

Hope that helps a bit.

yeah I got a 4 channel for speakers already but I dont want to take more space up. and want it to still look stockish.

so was just going to get a small mono or 2 chanel for sub.

[kodaz]

kodaz, that is the spot where I mounted my LC6.

I mounted the both amps on the sub box.

Cool, it's always nice to have someone who went before you. Can you tell me where you got your ACC wire from and whether you used the standard speaker cabling (thinking of keeping it to avoide too much interior dismantling).