Std Zorst Q

[mic]

Nah that was the inside diameter man where the exhaust will actually be flowing. Add another inch or so onto that 4 the outside.

[ratter]

Pipe is always measured outside and hose is measured inside.

You have a 3" dump

[JETURBO]

oh so technical can any of u wise men tel me the formula for exhaust area

[ratter]

oh so technical can any of u wise men tel me the formula for exhaust area

pye x (radius x radius)

[JETURBO]

nar nar I wasnt tryin to be smart that means nuffin to me break it down a little I have eight fingers two thumbs

[Buf-Phoon]

nah , soft . Lets play algorithms.... not. Those farkers do my head in

[ratter]

The radius of a circle is a straight-line drawn from the center of the circle to any point on its circumference .

The symbol p is called pi and is approximately equal to 3.141592654 , most high school teachers use it to two decimal places as 3.14

p is the ratio between the circumference and the diameter of a circle ..I.e

p = (circumference / diameter ).

Interestingly the value of p is the same for any circle ...

Area of circle = p x ( radius x radius ) = p radius2

if the Radius = R

then

Area of circle = pR2 = p x R x R

EXAMPLE. Find the area of the circle with radius 10 cm ..use p as 3.14

Answer

Here we have :

Radius = 10 cm

p = 3.14

Using the formula Area of circle = p radius2 = p x radius x radius

replacing radius with 10 cm and p with 3.14 in above formula we have

Area of circle = p radius2 = p x radius x radius = 3.14 x 10cm x 10cm = 3.14 x 100 cm2 = 314 cm2

[senna_T]

I was trying to watch Spiderman 3, after that ^^^ I can't concentrate on anything now well explained mick

[MICKAJ]

So the smallest Area in this exhaust is 3" as 2X2.25 is larger than single 3".

So there is no point getting a custom 3" fab'd for this car, only 3.5"

[hqracer89]

No, you need to work out the area of the twin 2.5 than add it up