Jump to content

Recommended Posts

  • Member
  • Member For: 20y 11m
Posted

1.5 60 foots have been done before, cross your fingers your drive shaft dont go twang....(Chris) G&D Jet and (Craig) Geea also ran 1.5 - 60 foot on M/T tyres....there is another one doesn't come to mind..

  • Replies 36
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

  • Legacy Donating Member
  • Member For: 20y 6m
  • Gender: Male
  • Location: nsw
Posted

congrats mg.

just a funny.

last week we were the car behind you in an rx7 my boss drove over the start line because your burnout was so big he couldn`t see where to go, they had to wait for the smoke to clear. :stirthepot:

  • Big Gun
  • Legacy Donating Member
  • Member For: 23y 11m 14d
  • Gender: Male
  • Location: NSW
Posted

Well done M.G.

All that time, patience and expense has finally paid off.

Rob

  • Legacy Donating Member
  • Member For: 22y 7m 23d
  • Gender: Male
  • Location: brisbane
Posted

congrats master G!!!!!!!!!!! that's one tough T... a well deserved 10 and when done in street trim its something to boast about :stirthepot:

  • No V6 for me thanks!!
  • Legacy Donating Member
  • Member For: 21y 1m 18d
  • Location: Newcastle
Posted

Great time Mate,

I missed your run but heard all about it soon enough.

Muzza.

  • Member
  • Member For: 21y 4m 17d
  • Location: nsw
Posted

well done geoff on a top effort,a good result for you and autotech.

I will have to get the ute up for a run sometime soon and see if I

can get some traction.anyway congrats.

cheers geoff

  • Member
  • Member For: 22y 3m 29d
  • Gender: Male
Posted (edited)

Well done Geoff. Great effort and well deserved time mate. Not bad for a car that weighs over 2 tonne.

Spiro

Edited by Sydney Tuner

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.



×
×
  • Create New...