IH8TOADS Legacy Donating Member 3,618 Member For: 21y 2m 12d Gender: Male Location: OZ Posted 12/09/05 04:37 AM Posted 12/09/05 04:37 AM After I had a new long block installed my T felt ever so slightly down on power when compared to the last motor. Anyway I was bored the other night so I connected a boost gauge to the back of the BOV. I did a few laps at full throttle and was only boosting to 5 psi. I didnt check the last engine so im not sure what that was running at (standard 6.5??). Im not sure if the management side got reflashed after the new engine, but I expect that it did. ANyway anyone fitted a gauge to their standar T and what PSI did it show??PS I realise that there is a chance that my connections were dodgy and this could explain only 5psi!!! Cheers all.
FPV TRANNY Im the one and only Legacy Donating Member 3,557 Member For: 21y 8m 13d Gender: Male Location: In my house Posted 12/09/05 04:40 AM Posted 12/09/05 04:40 AM When mine was stock it showed occasional spike to 7psi then back to 5 psi.Dodgy ford acutators.
Dan K Member 40 Member For: 21y 9m 12d Gender: Male Location: Stanthorpe Qld Posted 12/09/05 08:07 AM Posted 12/09/05 08:07 AM depends a lot on the load and the gear I am in. Sometimes it can read as low as 4.5psi but will build to around 5.5 to 6 as the load increases
Power The 'nice guy' Legacy Donating Member 314 Member For: 21y 5m 17d Gender: Male Location: Sydney (Area around Ryde) Posted 12/09/05 12:47 PM Posted 12/09/05 12:47 PM On the dyno my 2005 auto never hit 6psi (when stock).Stock dyno fyi attached.
HUSTLER Member 663 Member For: 23y 1m Location: Broken Hill Posted 12/09/05 01:17 PM Posted 12/09/05 01:17 PM when mine was stock, the psi never even got to 5, was between 3 - 4.5 mostly, and only made 162 RWKW
veczar Gold Platinum Member Member 1,081 Member For: 22y 2m 24d Gender: Male Location: Victoria Posted 13/09/05 04:23 AM Posted 13/09/05 04:23 AM My MKII under full load was max 5psi
veczar Gold Platinum Member Member 1,081 Member For: 22y 2m 24d Gender: Male Location: Victoria Posted 13/09/05 04:28 AM Posted 13/09/05 04:28 AM Now in 4th gear I can get to 15PSI and that is the max my guage shows.. but im assuming it isnt much higher than that (Dynomotive Melb Unichip)
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now