Just finishing up a rebuild on my transmission, I'm onto the last snap ring that holds the a and e drums together but can't figure out how it goes back in. There's two locking tabs that the snap ring needs to slide over.

Anyone have any experience with this?

forgot to attach picture

Align the ring so it would be in the correct position when installed, insert the large end then walk the tail around until it seats

Perfect! thank you very much, wasn't too hard at all

I'm glad you where able to decifer my description, was a touch sketchy

I had to think about it for a minute, but makes perfect sense now

Thanks

How's the box post rebuild?

It's holding up fine, was only a standard rebuild with new frictions, steels and seals just to keep me going for a while.

Thanks Roley94 and Ralph Wiggam for posting.

I have not rebuilt an auto gearbox, but seeing someone have a go and be successful, and someone else giving help makes it seem more possible that I will do it one day.

E clutch fried, and some hot spots on B clutch and c clutch?