^^ 5 inch - 125mm

^^ 5 inch - 125mm

really? that's huge!

Looking forward to the results.

lol it's not 125mm, it's 100mm. there's not much room to push the radiator etc further back

Edited September 22, 201412 yr by ripped6

sh*t......sorry I gave wrong info.

I was going off what I remembered from Jons thread and I obviously screwed up.

Nuffen worse than giving the wrong info so I'll just be over here in the corner :(

when I get some more coin together ill be getting one.

Roger that, I thought 125 was too big to fit up in a street trim car. The 100mm unit of PW requires fitment mods similar to what I assume you have carried out by the repainting of your front bar.

either way, still looks the shiznizit.

Its 5" thick on tanks as its a tube n fin. Bar n plates can have tanks as thick as the core. Made it hard as 5" in centre would be easy but 5" out on ends makes it very tight. You can relax Don, you were right lol

my bad Jon, I only measured the core itself, I say BenDoCo was only half right haha.

half right is better than half wrong so I'll take that guys........hehe

back to the corner I go

Based on that size I would say it would be fair to compare it with a process west 3 cooler, 500x425x100 is the process west size. I've done a few high 400rwkw pulls on the dyno and IT climbed 5 degrees.