Davidxr6t03 Member 58 Member For: 16y 3m 5d Posted 10/05/11 06:51 AM Author Posted 10/05/11 06:51 AM I had a similar issue with my 03 BA Xr6t. Took it too fraud they diagnosed dead pcm. I did as I suggested above and worked through all the earth and power feeds. Found a loose engine earth strap and a Loose pin in one of the BEM plugs. Fixed both those issues and the fault never came backWhat is a BEM plug?Thanks
Ralph Wiggum Moar Powar Babeh Legacy Donating Member 19,334 Member For: 20y 11m 26d Gender: Male Location: Perth Posted 10/05/11 06:54 AM Posted 10/05/11 06:54 AM Body Electronics Module. Located under the Icc behind the tissue box. Its part of the Can Bus coms circuit in these cars.Usually a good place too start if your getting coms errors, but a bad earth/power feed will also cause coms errors and the connections can drop out as the voltage drops due to bad earth/power
Davidxr6t03 Member 58 Member For: 16y 3m 5d Posted 10/05/11 07:02 AM Author Posted 10/05/11 07:02 AM Is there a DIY how to remove/get to it?Thanks
Ralph Wiggum Moar Powar Babeh Legacy Donating Member 19,334 Member For: 20y 11m 26d Gender: Male Location: Perth Posted 10/05/11 07:21 AM Posted 10/05/11 07:21 AM http://www.fordxr6turbo.com/forum/index.php?app=core&module=search&do=search&fromMainBar=1Have a look through these threads and the AV forum
ratter Member 6,793 Member For: 20y 3m 22d Gender: Male Location: @ my laptop Posted 10/05/11 09:21 AM Posted 10/05/11 09:21 AM Ecu's are become to fail in these cars, got another in the shop at the momment, my usual electronics people will not even reco them because they can not gaurantee them.
jdcustom Member 44 Member For: 17y 10m 10d Gender: Male Posted 10/05/11 11:36 AM Posted 10/05/11 11:36 AM who u use for computers mick?? logicar?? there a bunch of useleess prickshad a vito van here 3000rpm limit, been everywhere, went to merc dealer etc, not find problemsend computer to logicar comes back as tested ok, problem still there!!send computer to injectronics in hallam they repaired it runs fine revs right out now!!and that's only one example ive had from them
Paulie2256 Legacy Donating Member 7,441 Member For: 17y 9m 28d Gender: Male Location: SE Melbourne Posted 11/05/11 02:35 AM Posted 11/05/11 02:35 AM Are the ecu's failing because they sit in the engine bay where exposed to condensation and excessive heat and not behind the dash?
ratter Member 6,793 Member For: 20y 3m 22d Gender: Male Location: @ my laptop Posted 11/05/11 03:50 AM Posted 11/05/11 03:50 AM Apparantly they crack solder joints on the circuit board, they used to repair them, but then they would crack in another spot and buyers expecting warranty, so they have figured they do not want to deal with them anymore.
Davidxr6t03 Member 58 Member For: 16y 3m 5d Posted 11/05/11 11:50 AM Author Posted 11/05/11 11:50 AM Thanks Ratter, Ecu is getting replaced tomorrow, so fingers crossed
robbo k Member 414 Member For: 18y 5m 12d Location: Wollongong Posted 13/05/11 11:59 AM Posted 13/05/11 11:59 AM No, it will idle perfect until you go to drive it.Thanksyeah used to happen to me as soon as you put the foot on the gas it died. became very bad to drive on the roadApparantly they crack solder joints on the circuit board, they used to repair them, but then they would crack in another spot and buyers expecting warranty, so they have figured they do not want to deal with them anymore.sounds like xbox lol I found the ecu to be abit exposed to some other makes of cars. I know when I pulled one out a of ls1 ute was in the plastic box over it so nothing could leak or sit on it.
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now