Fpv Gt Front Rotors, Two 355Mm X 32Mm, Cross Drilled And Ventilated Wi

[sambo_xr6t]

hey guys im looking at getting FPV GT Front Rotors, two 355mm x 32mm, cross drilled and ventilated but I have the x chasser police pbr breaks just wanting to no if these will fit cheers

Edited 01/01/11 09:58 AM by sambo_xr6t

[WILDB]

Hey mate,

355mm are from the 4 and 6 pot Brembos, so you'd need them to fit these rotors. They'll only go on the front.

The larger single pot PBR rear is for a 328mm vented rotor. The Brembo rears are a 330mm rotor - also vented.

Hope that helps.

Will.

[sambo_xr6t]

so they will defently fit on the front that's all im looking 4

[WILDB]

Yes, but only if you have Brembo calipers.

[01txr]

Brembos or any other caliper that can accommodate a 32mm thick disc and fit the falcon.

Eg APracing, Alcon, PBR Mono Blocks.

If your after a larger disk the is a disk and bracket kit available from I think Race Brakes Australia down Sydney way, use to advertise them on Ebay.

And off memory I think it was $700.

Other than that keep searching EBay as from time to time good kits come up at great prices.

Ferntree Gully Wrecking Aldo was doing different kits as well had some really good deals on brembo kits, I think by memory new 6 piston with 355mm disks, brackets, pads, and lines for $2500.

I was spewing as I paid $3500 for my AP racing 4 pots with 330mm DBA5000's.

And didn't have $2000 for there 4 piston brembo rear sets.

Try those suggestions as they where my best finds.

[RHR]

You wanna sell your old callipers??

[01txr]

PM on old brakes.

Set of used 6 pots brembos on EBay start $2000