Sick To Fkn Death Of Loose Turbo

[ratter]

I have used inconel studs and the glenlock nuts with a new gasket on the turbo to manifold mount.

I purchased mine from Nizpro, but be warned they appear a little dear compared to normal studs and nuts, but if they stop your problems it will be worth it.

I beleive some of the problem is not just the nuts vibrating loose, but the studs themselves begin to stretch with heat and the load from tension, once they stretch enough it is as if the nuts are now loose and are free they vibrate off.

[tab]

whats it sound like? I've never checked mine.

Basically just like an exhaust leak

I'm sure Pauly would be checking them as part of a service like Ford should (but often don't)

[Dagabond]

Buy an SS and never have to worry about the fckers again....

[EZ2CME]

But then he'd be driving a boring ugly piece of

[bloosted]

Buy an SS and never have to worry about the fckers again....

if I can't drive it hard I may as well

[Full Monty]

Yep seconded Ratters advise, I had these Inconnel studs and nuts fitted by Nizpro, along with a steel gasket, havent had a problem since.

[bloosted]

Ratter did you just do turbo to manifold? or turbo to dump as well? both are coming loose on my pos

[ratter]

The car I did we only did the manifold to turbo, but if your turbo is coming loose it may be enough to start shaking to cause the dump to come loose.

[bloosted]

here's the fix I did Nissan studs,nuts and locking tabs

[Full Monty]

interesting, thanks for sharing.

how much did the tabs cost you? and how long now since you did this?

Gav