Newcastle Area

[Azid Rush]

haha this whole harden the F*#K up sh!t has taken off hasn't it

lol me and my mate have been saying it to each other since we were young lol but yeh certainly has picked up a bit

Where are they thinking about the motorplex going again? They still thinking about outside of the terrace?

[Bender]

lol me and my mate have been saying it to each other since we were young lol but yeh certainly has picked up a bit

Where are they thinking about the motorplex going again? They still thinking about outside of the terrace?

yes outside of the terrace, can't FKN wait. 10-15min cruze down the road and I'm there.

Maybe I should put a complaint about the noise it will make

[our06t]

if anyone who knows more about this could put a petition together and leave some copies around at places like blacktrack etc I'm sure you would get plenty of votes for it might help combat some of the negative responses the council might hear

[mickey_gee]

Hey

Does anybody know someone that has a CNC router and is interested in helping me make the Lasers box tougher?? Even better has anybody ever done this type of thing before?

Mick G

Edited 21/04/08 10:30 AM by mickey_gee

[our06t]

what did you do to the beast

cnc is one thing but wot sort of steel do you need and how complex is the part one off machining gets very very expensive

[TOM1111]

http://www.mgcarclub.com.au./htmpages/rngWd/rngWd.htm

here is some info on the motorplex

[mickey_gee]

what did you do to the beast

cnc is one thing but wot sort of steel do you need and how complex is the part one off machining gets very very expensive

It is a 1 off part and I dont really know what im doing? I will need to CNC route out an alloy housing in the box and replace that part with a piece of tool steel grade metal that can hold 2 bearings. Ive seen other people do it but im having trouble getting in contact with them, and they are in melbourne.

The beast is ok! needed a new clutch and I wanted to get new bearings and syncros in the box. Noticed that 1 bearing was not 100% so it was a good time to pull it all down.

MG

[our06t]

http://www.westonmachineshop.com.au/

try these guys haven't delt with them personally but their close to home

good to hear no major drama's ,I thought justin had a machinist he used sometimes

Edited 22/04/08 05:04 AM by our06t

[TOM1111]

well now my heater doesnt work :(

I dont know if it has anything to do with the cooler install

[our06t]

can't see why it would have anything to do with cooler install they are different sets of plumbing , when you are in the car turn fan on put it on cold then turn it to hot can you hear the servo motor under the dash doing it's job ,even if does sound like it;s working some people have had the arm come off the servo motor attachment therefor it won't open the hotwater valve

http://www.fordxr6turbo.com/forum/index.ph...1&hl=heater

try that

Edited 22/04/08 09:20 AM by our06t