Jump to content

Recommended Posts

  • Member
  • Member For: 22y 5m 10d
Posted

Hi

As most of you know there is a small covered panel below the rear air vents. The cover can be removed with a little push however it is difficult to replace once removed so careful if you are doing this for curiosity only.

The fairmont ghia has a small light installed in this panel however the XR does not have the wiring in place (not sure about MKII). I removed the center console etc (see different thread for instructions) to gain a track from the panel to the front passenger footwell light. I piggybacked wires from the front passenger footwell lights through the center console to the open panel.

Ordered the lens assembly for the fairmont ghia rear footwell light ($11.20) only to find that it is only the lens - no light holder. :spoton: Picked up a trailer light from the local K-Mart ($3.50) and modified the light holder to fit inside the panel (very easy) and attached lens - works great :spoton:

post-3878-1120622803_thumb.jpg

post-3878-1120622829_thumb.jpg

  • Flower Power
  • Legacy Donating Member
  • Member For: 23y 11m 15d
  • Gender: Male
  • Location: Sydney
Posted

Well done! :spoton:

When I have a free weekend I'll be doing the same thing.

Guest mercurysteve
  • Guests
Posted

ditto on the pics, they don't show much mate. :msm:

  • Legacy Donating Member
  • Member For: 23y 21d
  • Gender: Male
  • Location: Townsville
Posted

could you take a pic with the clear cover off so I can see the mod that you did?

Thanks, Brett.

  • Member
  • Member For: 22y 5m 10d
Posted
could you take a pic with the clear cover off so I can see the mod that you did?

Thanks, Brett.

<{POST_SNAPBACK}>

OK

Sorry about the quality of the photos but it is hard to get under the rear air vents with a camera and to focus. However the first photo shows the small panel with cover under the vents and the second shows the mod completed with the light. The light is much brighter than the photo but it just would not come out on photo. I will try to get another photo with the lens removed but that wont show much apart from a globe holder attached to the edges of the panel with a couple of small screws. :spoton::pinch:

  • Member
  • Member For: 23y 2m 17d
  • Gender: Male
  • Location: Melbourne.
Posted

I have lightened the photos so it is now possible to gety a better understanding of what is trying to be explained. :spoton:

post-1436-1120820603_thumb.jpg

post-1436-1120820620_thumb.jpg

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...