Everything posted by jono
-
Vic Spotted & Chat Thread
I'd be up for a cruise tonight as well if anybody is heading out?? Jono
-
I Left My Mate Behind
Yep I left the purple taxi today with Joel from PGS in Mornington to fit an 12 pound actuator, 4" Dump pipe, Cat and 2.5" twin system Then give it a tune After finding the turbo was about to fall of the exhaust housing and also all the bolts on the actual turbo were lose he had finaly finished fitting everything up and tomorrow is tune day. Here is hoping everything goes well and nothing goes bang
-
Vic Spotted & Chat Thread
I might come down for a blast, weather pending Just around the corner from home
-
Next Vic Cruise
Sounds like fun I might be a starter in that depending on dates and finances
-
Is This Good?
Yep that's the one Saw it at PGS a little while ago Joel did a bit of work on it while it was there The rear tyres are nothing special in fact I dont even think they a both the same tyre
-
Is This Good?
Was that the green one??
-
Is This Good?
PGS is the 4wd place in Mornington Joel their tuner has been a mate of mine for years He is a awsome tuner Running 19" Street tyres with 40 psi I did have the auto set across to the sports mode on aute shift cycle so I think that restricts it to a three speed Would I have been better off leaving it in the standard setting?
-
Advice Please 3"Twin Exhaust For Ba Turbo?
Currently running a 3" single with standard dump, actuater, and cat
-
Advice Please 3"Twin Exhaust For Ba Turbo?
Comparing between a new twin 2.5" or a second hand 3" twin looking at putting in a 4" Dump and a 5" cat Currently running in the 12sec mark and would like to nuch the 11's Yet to fit a 12 pound actuator understand I will need a tune no matter what I get Look forward to your reply.
-
Is This Good?
Went to Calder last Sunday and did 13.05sec, 12.72sec, and then this; Mods are aftermarket intercooler, 3" single exhaust, under battery tray cold air pickup (process west), fuel pump, Nizpro springs,reco trans and small 2,000 stally,and tuned by Joel at PGS Mornington Series 1 BA XR6 Turbo look forward to your comments Thanks Jono
-
Calder Park Friday Night Drags Are Back!
I got 2 runs in 12.95 and a 12.73 need to get more boost of the line Jammed packed and poorly organised
-
Vic Spotted & Chat Thread
I'm up for a cruise have 3/4 tank of juice and all tuned up with a fresh transmission
-
Vic Spotted & Chat Thread
when and where do ya what to meet up Happy to PM nummber
-
Vic Spotted & Chat Thread
Dinner finished quicker than expected ready to rock and roll if anyone else is up for a drive tonight
-
Vic Spotted & Chat Thread
I'm probably 1 1/2 hoursw to 2 hours away Have to have tea with the Family first
-
Vic Spotted & Chat Thread
I'm, keen for a drive if anyone else is up for one Located down in Sunny Franga (Frankston)
-
Vic Spotted & Chat Thread
On PGS's Dyno tuned by Joel down there 250RWK on a nortoriasly tough Dyno True test really will be when she gets to run a 1/4mile They have had cars makes 320rwk on other dynos only to making around 270rwk on there's a week later with no mods to the car But seat of the pants the new tune is pumping looses traction at wide open throttle at 50kmph boost comes on hard and feels real strong can't wait to run it down the 1/4 may be able to get down to Heathcote in May for the forum weekend
-
Vic Spotted & Chat Thread
The car is now going awesome with the new injectors and final tune couldn't be happier
-
Vic Spotted & Chat Thread
There was love There was rain There was a servere lack of traction and fog on the top of Arthurs Seat
-
Vic Spotted & Chat Thread
Cool see ya there between 8.45 and 9.00
-
Vic Spotted & Chat Thread
I'm based in sunny Frankston More than happy to head south or North
-
Vic Spotted & Chat Thread
Yeah I might be up for a drive tonight when and where
-
Vic Spotted & Chat Thread
If ya meeting any where near Frankston I'd be up for a bit of a cruise As might another mate with a new manual FG
-
The Glen 2 The Lake (vic Cruise)
I'm still planning to go picking up a mate at nine and see you guys at the Glen soon after Jono
-
Oil Pressure Sender
I hope someone can help with this question I want to fit a electronic oil pressure guage to the BA turbo Does anyone know where the original sender is and to install the electric one do I just buy an adapture and screw both of them in or do I replace the oil pressure switch with the sender. Thanks in advance Jono