Then there’s the coolant I just wasted, the pump which is new and I have the pulley I just brought..... that $30 bucks just went up! And 2 pumps!!! Plus I have a steel pulley to replace the sh*tty plastic one that just shattered so if I get a “$30” pump without a pulley it would still set me back $50 to have a shop press the steel one on for me.... so yeah I should just buy a pump......

I’m just asking to see if someone already has the tool I can borrow, that’s it.

 

 

16 hours ago, Puffwagon said:

Can ya tack weld something to it to pull it off? 
 
How about sawing it off? A cut up either side? 

No welder and little room for my grinder

Yeah man I understand that it's not ideal but I wouldn't be losing a day or more wages over it.

 

Anyway I'm sure you'll work something out.

OP how do you intend to press the new steel pulley on , in the car.  A 3 leg puller may get it off but you need to whole kit to press it back on...

Edited July 29, 20188 yr by arronm

The above kit does both but I have a pulley installer already I got years ago too