Jump to content

Recommended Posts

  • Member
  • Member For: 11y 3m 13d
Posted (edited)

Hi all I would like to ask you all if you have come across any rough idle problems in a ba Xr6 turbo I have replace plugs coils oxy sensor and I still have the problem every time I changed those parts it ran ok for about a day then it would come back I also have a bit of powers loss it doesn't seem to boost as hard as I hoped I am thinking about replacing the turbo intercooler piping but I don't know for sure there is a boost leak or an issue with the piping to begin with I would like to know if there is a way that I can test for a boost leak thanks and look forward to your response

Edited by Hotxrturbo6
  • To Loud
  • Legacy Donating Member
  • Member For: 14y 9m 25d
  • Gender: Male
  • Location: WA, Perth
Posted

Welcome to the forum. We hope you enjoy your time on the forum.

 

I think you might not get a reply any time soon, as we tend to fear those the sign up to the forum and post once.

When they get the answer that they after, they tend to run and never to be seen again.

 

We normally advise new member to use the search function at the top right to find the answers you want, as these sort of questions have been asked previously.

Search and yee shall find.

Hopefully someone with the know how will reply soon. This post is a bump for your thread as well. :)

  • Legacy Donating Member
  • Member For: 11y 5m 2d
  • Gender: Male
  • Location: Canberra ACT
Posted

Have you got a boost gauge and if so have the typical readings changed? Or if you have an obd Bluetooth adaptor and the Torque app (both are cheap if you don't) you can get boost pressure from the ECU and then let us know.

Is the car stock or if not what mods?

I'm guessing it would be hard to pressure test the intake system for leaks without some sort of special equipment. But that's getting beyond my level of expertise.

I'd check all of the clamps before doing too much though, if you haven't already.

  • Like 1
  • Member
  • Member For: 11y 3m 13d
Posted (edited)

Thanks El my mechanic has just suggested to put a boost gauge on I also have an obd wifi adapter but I use an ipad with a dash command app plus obd doctor but I still can't get it to work properly I also had the cat checked out today and it was fine the only other thing I'm gonna try now is the intercooler piping maybe injectors or fuel pump thanks again for your reply and hope to hear more advice or suggestions

Edited by Hotxrturbo6
  • To Loud
  • Legacy Donating Member
  • Member For: 14y 9m 25d
  • Gender: Male
  • Location: WA, Perth
Posted

Where are you based?

Perth? Melbourne? Sydney? Brisbane?

  • Member
  • Member For: 11y 3m 13d
Posted (edited)

Hi masda I am based in Melbourne thanks for the welcome looking forward to any suggestions you may have

Edited by Hotxrturbo6
  • Member
  • Member For: 17y 10m 11d
  • Gender: Male
Posted

Throttle positon sensor. Common issue. Causes rough idle and lack of power. Pull the throttle body off and clean it. Might help your issue if not fix it and it'll only cost a can of carby cleaner.

 

  • Like 1
  • 1 month later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...