04 Ba Xr6T Cv Joint Tail Shaft

[jas98]

Can anyone confirm that the cv joint that bolts to the diff on the tailgate on a ba xr6tsedan same as Mon turbo ones? Hardy spider list them as the same but are they?? I have one from a low k xt.

[jas98]

I ment tail shaft not tail gate. So anyone know??

[Ralph Wiggum]

Yes they are the same...dunno bout the tailgates tho, Im pretty sure the turbo tail gate has another badge?

[jas98]

Haha... cheers man. So from what I can gather the cv joints the same. Uni joints the same and depending on the shaftvthey use same centre bearing?

But the rubber part near gearbox are different? How do unrecoverable that I have unbolted all 6 bolts but it still won't split

[Ralph Wiggum]

There's a spigot on the end of the tail shaft that goes into an alignment bush in the yoke. They can be tight. Use a long screw driver or pay bar to pry it back and it should release.

Afaik the turbo and non turbo couple is the same

[JVK]

Rubber coupler is not the same. Turbo is a tad bigger between the bolt centers as is is the yoke.

[jas98]

Thanks for that. Do you know of anyone that sell them? I see heaps on eBay bit all say for non turbo. Ford told me earlier that thevturbo ones u have to buy the whole shaft at $1800...as they only make the non turbo ones separate...I see there is an alloy one on eBay that says for all...non turbo and turbo...bit isothermal any just rubber ones

[jas98]

Thanks for that. Do you know of anyone that sell them? I see heaps on eBay bit all say for non turbo. Ford told me earlier that thevturbo ones u have to buy the whole shaft at $1800...as they only make the non turbo ones separate...I see there is an alloy one on eBay that says for all...non turbo and turBo. Which means there saying there the same. So does anyone make just a rubber one that rits

Edited 25/02/15 01:01 PM by jas98

[PhilMeUp]

Thanks for that. Do you know of anyone that sell them?

See if your local Hardy Spicer branch has any suggestions - http://www.hardyspicer.com.au