Gday guys im trying to work out what bang for buck or pros and cons for plenum/intake side is the way to go

Process west

Nizpro cobra intake

viper atomic

plazmaman

Are there any bad upgrades? or bad choices with these and what one works the best?

There is not alot of info out there about people using these,I do see people who make these go on about how theres is the best,I personaly like to see people finding good resualts on these so I know I can too.

Cheers.

I had a rapid cooler and turbo side intake... Made 310rwkw at 18psi!

Got rid of the cooler and fitted a plazmaman cooler and plenum! Power went up to 345rwkw with 16psi so the plazmaman gear deffanlty is good. These figures were done at a reputable tuner so I'm not just talking out of my ass lol

All in all can't fault plazmaman for service and workmanship. Top notch gear.

+1 for plazmaman

I have process west plenum.

Hypertune/dlm one looks the goods though

all the above plenums give great results & value for money but the one that stood out for me was the Hyper tune not the cheapest but very impressed with the final resualts

joe

Iv got a new and unused Plaz plenum sitting here if your interested...

Shame, but im selling up.

PM me if your keen!

I can get my hands on a process west plenum but im unsure if that's the right thing to do?

I take it needs a aftermarket fuel rail or the stock one fits?

is the stock fuel rail big enuff for around 500-600 hp atw?

What were the differences joe?? I read some where that the hypertune will give more hp but less torque than the process west?? is this true or is the hypertune better every where in the rev range??

I can definitly say that it was good all round as far as torque goes the one in question is on my sponcers section I made 418rwkw & 1200nm

joe