Fg Plastic Elbow Replacement

[Process West]

At this stage I can only confirm that the elbow will fit with my stage 2 piping kit. It wont work with the factory piping.

I wont be taking anymore orders for this part at the moment. The tooling is being produced to have this cast in one piece and will be 4-5 weeks away

Kev

[Bomber]

At this stage I can only confirm that the elbow will fit with my stage 2 piping kit. It wont work with the factory piping.

Kev

Kev I have a hard pipe kit in 63mm (not yours) that obviously lines up with the current OEM elbow. Given your stage 2 also lines up, so finished height must be the same, is the only difference that prevents the OEM hoses from being used length?

[f6mark]

nice. im geting one..

[Process West]

Kev I have a hard pipe kit in 63mm (not yours) that obviously lines up with the current OEM elbow. Given your stage 2 also lines up, so finished height must be the same, is the only difference that prevents the OEM hoses from being used length?

The problem is the factory plastic intercooler hose is approx. 63mm ID where it clamps on....my elbow is 76mm OD.

If you buy a 3in to 2.5in straight silicon hose joiner then you should be able to use my elbow

Kev

[Bomber]

If you buy a 3in to 2.5in straight silicon hose joiner then you should be able to use my elbow

Kev

cheers Kev.

[unclewal]

Mine arrived today, packed like it was made of fragile glass, unbelievable quality just in the shipping, the elbow is flawless, comes with everything for a straight swap over, fitting it tonight, thanks again Kev, another quality bit of gear for the best price in the market !

[Nolz]

Is the new batch of cast elbows available yet?....It's the missing piece in my cars intercooling puzzle.

[Process West]

$99 from memory.

Correct the Process West part below is $99.00

[Barra]

And you have to tap your own thread for the pressure sensor for the top pic. Hmmmmm....

[RAP1D]

You re-use the OEM self-tapping screw.