Jump to content

Recommended Posts

  • Legacy Donating Member
  • Member For: 16y 9m 4d
  • Gender: Male
Posted

ok thanks guys .daniel do u have a sunnys holder in your bf?

ill still prob wait to see prestige again when they have got one.they had photos but not a good angle ,custom said the head linning wont come out nice as its a fairly steep angle up to the sun shade if I use the sunny holder.

  • Replies 44
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

  • Member
  • Member For: 23y 2m 14d
  • Gender: Male
Posted

I opted to have the sunglass holder taken out; it *can* stay, but it looks cramped and silly.

It was no great loss to me as I never used it because I could hear them rattle in the holder on some roads etc...

The holder also feels cheap and plastic (it is, obviously lol) but I mean in comparison to some other cars I have driven with a glasses holder and it honestly did not rate with me. :roflmbo:

Good riddance to the thing!

  • Throbbing Member
  • Legacy Donating Member
  • Member For: 17y 7m 15d
  • Gender: Male
  • Location: Victoria
Posted

I take it most of you have the hollandia 700 fitted? Whats the tilt function like, I'm looking at a car atm with one in it and the tilt seems to be jerky, I asked the sales dude and he said its normal. Its like it has 4 increments, so you have to press the button 4 times to get it fully tilted open.

Oh and where'd you get your colour coded handle/switch from daniel? easy to swap over and how much it set you back? PM me if you don't wanna say here..

Cheers

  • Legacy Donating Member
  • Member For: 17y 6m 25d
  • Gender: Male
  • Location: Melbourne
Posted

Never seen one of roofs do that. Maybe there are different modes the controller can be put into. I know mine just goes straight to full open when I hit the up/tilt button.

Doesn't really matter anyways, you just set the 1 and 2 memory buttons so you dont have to worry about these things. 1 is for full tilt. 2 is for fully open. Anything else is just gay.

  • Member
  • Member For: 17y 10m 16d
  • Gender: Male
  • Location: QLD
Posted (edited)

no that's not normal, I've had 2 now an both been the same. One push > and it will tilt open all the way, when tilted one push < will close all the way. Hold < when fully tilted an it will do the increment thing. If its original control it should also have 123 for saved positions. Take the fuse out for 2 mins an the controller will reset an should retrain itself when restarted, if not it can be forced to retrain, forget how.

few minutes to late what he said up there....

Edited by timbos99
  • Member
  • Member For: 23y 2m 14d
  • Gender: Male
Posted

Yes, most of us have the 700 series in our cars.

There is no way that the movement you described is normal, like arm said, just have the preset buttons 1/2 set to full tilt or full open... I cannot rem using the manual slider buttons other than to test the worked when it was installed LOL!

My colour coded handle along with new button/memory pod set me back around $80ish together inc GST from The Sunroof Centre in Noble Park.

I emailed custom sunroofs and prestige sunroofs also - custom said 130ish for the two and there was no answer when I tried to call them to confirm pricing, prestige are still yet to reply :badabing:

I have booked to get my sunroof fully serviced, alined and to see if I may need to new seal to get rid of some of the wind noise as Im positive it was silent when I had it installed years ago by prestige. The seals are pretty expensive, I hope it just needs adjustment!

  • Member
  • Member For: 17y 10m 16d
  • Gender: Male
  • Location: QLD
Posted

Doesn't pressing the manual slider button once either open it to full tilt or slide full open? if so then why set 1/2 to this again...

I find the quietest tilt when driving is 2 steps down from full tilt so this is what I set 1. I then set the lowest tilt for number 2 for when I park, as its low enough that you can't easily get your fingers under to rip it open.

  • Member
  • Member For: 23y 2m 14d
  • Gender: Male
Posted

The manual slider buttons (arrows) will not automatically go to full open/close/tilt when pressed only momentarily - it will just begin to open/close/tilt while pressing them.

You'd have to hold the button in till it got to the position you wanted - this is why they are manual buttons.

The presets (numbered 1 & 2) are the automatic buttons and they will automatically slide to your preset position (any position you like as its user set) with one quick touch.

If you hold these buttons, you will reset the saved sunroof position for that number to the current position of the sunroof.

  • Member
  • Member For: 17y 10m 16d
  • Gender: Male
  • Location: QLD
Posted

interesting, with both sunroofs I've had the manual button opens to full (either direction) with a single push... they also do what you've described if held down.

  • Member
  • Member For: 23y 2m 14d
  • Gender: Male
Posted

timbos99, you're right!

I just double checked to confirm this when I went out tonight and I was incorrect.

As said above I never use these buttons and must have been holding the button down too long for it to be a single push in the past lol..

So to clarify, if you press the manual buttons momentarily, the roof will go to the full position. :buttrock:

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.



×
×
  • Create New...