Hi,

The plastic material used for the FPV bumpers seem to be near impossible to repair. It is made of a special material that just 'fizzes' if you try to plastic weld it.

How do you do your repairs? Staple gun, and a 2-pack Epoxy glue on top of that seem to work. A bumper shop said this glue cost $500 for a bucket, so I had to pay $30 for a little bottle of this glue.

God damn.

I just dropped my front bar off to be reapired after the dude I bought my car off blew it out on a kerb. I hope this isn't going to be too expensive now that you have said they are un-plastic weldable! My one actually had a chunk missing out the front of it and was covered in racec tape (made me so disgusted to look at it that way...)

Ill let you know how I go getting it fixed