Jump to content

Recommended Posts

  • Member
  • Member For: 18y 13d
  • Gender: Male
  • Location: Perth
Posted (edited)

hi I just wanted to know if any body has any problems with the rear axle in the fg xr6t. I took my car down to the drags last week and I took off from the line with launch assist, I got a sh*t load of axle tramp then went about 20 metres and the drivers side rear axle snapped. ford is still deciding wheather or not to cover it with warranty

Edited by tab
de-fonted
  • Legacy Donating Member
  • Member For: 20y 8m 25d
  • Gender: Male
  • Location: Hobart, TAS
Posted

Oh dear, sorry to hear that...

How many revs had you stalled it up to??

You didnt tell them you did it at the drags did you?

  • Member
  • Member For: 18y 13d
  • Gender: Male
  • Location: Perth
Posted

I had it stalled up to the standard 3500rpm with launch assist. I didnt tell ford that I was down at the drags. I just cleaned of all the rubber and took it in and said that it snapped while using launch assist

  • Member
  • Member For: 19y 5m 6d
  • Gender: Male
  • Location: balmain
Posted

id be pissed if its not covered after all they installed launch assist into the car from factory ?

lets see how long it takes untill ford flash the computer so you cant use launch assist above 2000rpm or something once a few more brake some more parts

  • Member
  • Member For: 18y 6m 16d
  • Gender: Male
  • Location: The Ville
Posted

id say its covered because launch control is there and to be used as Trevs said it comes out factory with it

  • Forged Member
  • Legacy Donating Member
  • Member For: 19y 7m 20d
  • Gender: Male
  • Location: SW Sydney
Posted

Did you drop the clutch or feed it out mate? Much axle tramp?

  • Member
  • Member For: 18y 13d
  • Gender: Male
  • Location: Perth
Posted

I just dropped the clutch because that's what it says in the manual and I did have alot of axle tramp

  • Member
  • Member For: 23y 1m 21d
  • Gender: Male
  • Location: Newcastle
Posted (edited)

That axle tramp sounds very unhealthy when it happens. It does sound like something is going to break.

Edited by Benny
Posted

Hopefully this will prompt Ford to make some decent axles/cv's that will be standard fitment from now on??

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...