Turbosmart Hoses

[jasper361]

Can anyone confirm what size tubosmart silicon hose is required to replace the useless rubber joiners on the crossover, TB, and turbo? I think it is 75mm or 83mm in diam.

Cheers,

Scott

[RAP1D]

75 for the turbo inlet pipe, both ends.

83 for crossover to throttle body.

[IH8TOADS]

I sqeezed 76mm onto the TB.

[FSIX]

avo turbo world in moorabbin, 3.25 inch diameter will cut it for you by the inch they have it in black and know all the sizes used and length needed to replace the factory rubber junk.

[SavageF6]

Hey, glad I came across this thread. Thanks guys.

[jasper361]

sometimes the search function does work

I only just fitted these myself, much better!

[SavageF6]

So you need 2 x 75 and 1 x 83 correct Jaspe?

[KW CONNER]

So you need 2 x 75 and 1 x 83 correct Jaspe?

I got a 76 mm over the throttle body as well .

[StevesXR6T]

just replaced mine and one of the ducts that goes to the crossover is a different size to the crossover. So it was a tight fit on the crossover and a loose fit on the duct. Its a crap set up why not make it all the same size.

[Toxic Beast]

hey guys, this is actually the thread I've been looking for.

So which place is better to get a replacement pipe or hose for the factory rubber one that connects to the cross over.

so that rubber hose is 2 inches? and the cross over end is about 2.2"

is the other end where it connects to that alloy pipe 2" as well?

or does it go smaller or soemthing.

I'm wanting to replace my factory rubber hose with a 2.5" alternative and still use the cross over. so I'm hoping its possible.