Jump to content

Recommended Posts

  • Member
  • Member For: 15y 5m 15d

As the title states, I need a hand... I've recently purchased a ba mk2 xr6t. finally acquired the cash for some go fast bits... looking at: 14psi actuator, set of deka's, valve springs. And this is where I run into trouble, do I go a xforce stainless system and a wog/ f6 cooler OR rapid v3 and just change the cat around.

Any help will be appreciated.

cheers, mat.

Link to comment
https://www.fordxr6turbo.com/forum/topic/68831-help-a-n00b-out/
Share on other sites

  • Donating Members
  • Member For: 17y 10d
  • Gender: Male
  • Location: East Suburbs Melbourne

I think your better off getting the better cooler so get the V3, the exhausts on these cars are not too bad, changing the cat will free up alot of restriction.

Good luck with it

  • Tampon inserted, Auto Acquired, next purchase a new handbag
  • Donating Members
  • Member For: 17y 1m 28d
  • Gender: Male
  • Location: Vic

Another vote for the V3 and cat, maybe centre muffler out too while your at it.

That should see low 300s (With some injectors) which is the limit of the ba motor and if its auto your 4 speed as well.

Edited by henz
  • Member
  • Member For: 15y 8m 26d
  • Gender: Male

get a 5 inch 100 cell cat n remove centre muffler might want to put hot dogs in but its a personnel preference thing theres a few articles around about it

Edited by Brendan XR6-T

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'