Jump to content

Recommended Posts

  • Member
  • Member For: 16y 10m 22d

Hey guys,

I have a left over HKS 300mm x 600mm x 76mm cooler (2.5" in and out on opposit sides)from another project (not cheap crap) is there enough room for it in a XR6 Turbo Mk1? As it should be cheaper to get pipes made up rather than buying a full new kit....

thank

G.

Link to comment
https://www.fordxr6turbo.com/forum/topic/49043-using-a-jap-cooler/
Share on other sites

  • Member
  • Donating Members
  • Member For: 19y 1m 19d
  • Gender: Male
  • Location: Sydney NSW

It depends on the endtank size if it will fit or not... got a pic of it? or link to one similar

MRdose has a GTR style cooler... as in, GTR replacement

  • Member
  • Member For: 17y 6m 10d
  • Gender: Male
  • Location: Sydney

well we had to mount mine infront of the bar reinforcement cuz of the end tanks but it worked out well for me cuz the owner before me seems to have run up the back of somethin causin the bar to pinch in so a normal cooler wouldn fit, we just used the normal cold side with a fabricated pipe off the cooler if im correct haha I prefer it stickin out more anyway :doc1:

post-13959-1219675777_thumb.jpg

  • Member
  • Donating Members
  • Member For: 19y 1m 19d
  • Gender: Male
  • Location: Sydney NSW

We set up this cooler with our High Flow cold side, but had to change and custom make the lower section, and a short section for the hot side to plumb into.

Great flowing and cooling intercoolers, they just take some modifying of the front bar/bumper to fit, and the spotties have to go to make room for the masive end tanks.

Very aggressive look from the front though, very jap/drift looking.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'