Bf Xr6t Exhaust Onto A Ba

[MRAH33]

hey guys just wanted to ask a few questions in regards to fitting a BF XR6t ute exhaust onto a BA xr6 ute.

1. will it work?

2. will it need any modifications to make it work?

3. how much of a difference will it make?

thanks,

roger

[senna_T]

They do fit in there, do you have the entire exhaust or just cat back? If its cat back I think you need to get a merge made up for where the turbo system is twin and the NA is single

[MRAH33]

the exhaust is a full (from the dump to the tips)

would this be a straight bolt on to the na6?

[senna_T]

you would have to get an exhaust shop to match it up because obviously your N/A will be different where the turbo should be!

[MRAH33]

I see...how much you think it will cost to get the ehxaust shop to match it up?

btw...thanks for the help senna

roger

[senna_T]

wouldn't cost more than a couple of hundred fully installed I guess, just get on the phone and speak to some shops, its not a big job so it shouldnt take them too long

[Doogstar]

wouldn't cost more than a couple of hundred fully installed I guess, just get on the phone and speak to some shops, its not a big job so it shouldnt take them too long

You should ask this in the NA section or on AFF, it has been done lots of times and sounds really good.

You will need to get a Y piece made up from the cat to the twin pipes, shouldn't cost more than $300 I would think. Put a 3" Magnaflow metalcat on it at the same time, probably another $350 supplied and fitted but will be so worth it as the standard Ford cat is crap.

[MRAH33]

ok thanks for the heads up mate. I will pass the info onto the dude that wants to buy the exhaust..

roger