Boost Sensor On Ic Pipe Under Battery

[O2STOCK]

Mummy, I want a turbo like that for my birthday

See my PM (Manifold info)

[Process West]

Plug and play baby will see if I can find a picture of mine

Just to avoid confusion my intercooler kits normally come with everything needed to connect up the boost sensor.

MUZ purchased my intercooler without the piping kit.

Kev

[MUZ580]

Can you see the welded tag in the front for the MAP sensor and the provision for the boost sensor on the rear.

You will need to extend the wiring............. 3 wires piece of cake

Alright, so I've got the Boost sensor part sussed out now, I just have to have a 3/8 fitting welded in the colde side and extend the hose to the fitting.

What about the MAP sensor? MAP = Manifold Air Pressure? What will I have to do for that?

[groper]

Mummy, I want a turbo like that for my birthday

holy sh*t, that a big turbo! I wanna know more about this car

[IH8TOADS]

MAP = Manifold Absolute Pressure

[IH8TOADS]

Here on the right hand side pipe are the sensors, you ask about

This is another FIST car which makes my 398RWKW look harmless

Very Nice

[BFHOON]

.boost sensor alla plazmaman.

Edited 12/07/07 10:11 AM by BFHOON

[O2STOCK]

Alright, so I've got the Boost sensor part sussed out now, I just have to have a 3/8 fitting welded in the colde side and extend the hose to the fitting.

What about the MAP sensor? MAP = Manifold Air Pressure? What will I have to do for that?

You must also connect this MAP sensor it is not as easy as the boost guage as the unit is rectangular with a single mounting hole and a rubber oring seal. Zoom in on he pic of the balck F6 you will see it clearer then what it is own on my photos

James

[MUZ580]

You must also connect this MAP sensor it is not as easy as the boost guage as the unit is rectangular with a single mounting hole and a rubber oring seal. Zoom in on he pic of the balck F6 you will see it clearer then what it is own on my photos

James

So I've outlined the Boost sensor right - where is the MAP sensor? Keep in mind I'll be using the stock plenum.

Mine when finished will look like this but with a BOV and the 3/8 fitting welded in for the boost sensor.

[

[Process West]

So I've outlined the Boost sensor right - where is the MAP sensor? Keep in mind I'll be using the stock plenum.

Mine when finished will look like this but with a BOV and the 3/8 fitting welded in for the boost sensor.

[

Boost sensor/map sensor same thing.

Weld a 3/8 barbed fitting into your new pipework somewhere near (before) the throttle body. Then run a 3/8 hose across to the boost sensor mount I sent you. Doing it this way means that you dont have to cut and extend wires.

Kev