Jump to content

Recommended Posts

  • Member
  • Member For: 18y 1m 25d
  • Gender: Male
  • Location: Virginia, (USA)
Welcome Telionis.

As you're mentioning hp figures, Id thought Id clarify that aussie hp/kw figures need to be adjusted up by 12% to read in U.S. speak.

Thanks for the welcome all.

In regards to the horsepower? How so? Ours manufacturers report net crankshaft horsepower (with all accessories attached). Not the gross figures like the 1970s where the engine was put on a chassis-dynos with no exhaust and no accessories to drive. Most of the figures I quoted were hp at the wheels (the Cobra for example, 700 rwhp ~= 850-870 bhp SAE net).

Which standard do you guys use? ISO's? The EUs? A domestic OZ standard?

_________________

If your currancy is doing better than usual now (and our dollar is weaker than it was 5 years ago), your cars should appear more expensive than usual to an American!?! Not the other way around!?!

Edited by Telionis
  • Replies 38
  • Created
  • Last Reply

Top Posters In This Topic

  • Member
  • Member For: 21y 1m 7d
  • Location: MENAI, NSW
Thanks for the welcome.

In regards to the horsepower? How so? Ours manufacturers report net crankshaft horsepower (with all accessories attached). Not the gross figures like the 1970s where the engine was put on a chassis-dynos with no exhaust and no accessories to drive. Most of the figures I quoted were hp at the wheels (the Cobra for example, 700 rwhp ~= 850-870 bhp SAE net).

Which standard do you guys use? ISO's? The EUs? A domestic OZ standard?

Ford Australia use SAE. Expensive Daewoo on the other hand use DIN.

I was talking about 'at the wheels'. The US measures wheel hp on the top of the single roller whereas we use 2 rollers and the tyres sits in the vallley in between which accounts for the difference. I'll try and search for the thread I got my info from. Its gonna be a challenge as it was was over 3 years ago on the aussie LS1 forum.

Regards,

Max

  • Im the one and only
  • Donating Members
  • Member For: 20y 5m 3d
  • Gender: Male
  • Location: In my house
Stop your whinging. When most of your cars, especially at the higher end are 2-3x cheaper you have it much better. Do you think I'd be driving a

Ford that costs $60K, when an Audi RS4 only costs $66K in the US and is $165K here. And my pay would be the same or higher in US dollars for my profession. You guys

get cars we don't and vice versa.

Come to Australia and you'll be complaining within 2 weeks how pathetically low our speed limits are and how you get booked every 10 minutes for doing 2m/hr over the speed limit or how there are speed cameras everywhere you turn.

Only in the your state.Up here they dont really give a sh*t.I love living in Australia and further more I love living on the Gold Coast. :roflmbo::B):

Guest casgeroth
  • Guests
BTW - the closest highway to me has a 55 mph limit. It is divided and it is an interstate highway (it is not some silly side road that goes from town to town). If you've really got lower speed limits than that, then I have to concede that you're worse off in that regard.

55mph limit = 88.5kmh.

The top speed limit for us is 110kmh (68.4mph) which is found on most highways/freeways.

Some parts of the Northern Territory are up to 130kmh, but that only if you could be bothered going up there.

  • Member
  • Member For: 18y 1m 25d
  • Gender: Male
  • Location: Virginia, (USA)
55mph limit = 88.5kmh.

The top speed limit for us is 110kmh (68.4mph) which is found on most highways/freeways.

Some parts of the Northern Territory are up to 130kmh, but that only if you could be bothered going up there.

Most of our interstate (cross-country) highway system is set at 65 mph. The nearest major highway for me is about 30 min away (goes from upstate New York to Arizona ~ 3500 miles) and is limited to 65 mph, going down to 60 mph near cities. The smaller highways (US routes), like the one I use on a regular basis to get to work and the other nearby towns is capped at 55 mph. It is still considered an interstate, but it's much smaller, probably one and a half times than the length of the state (~ 500 miles) only two lanes in each direction, but still divided. I've never seen any highway in this part of the nation that allowed faster travel, though supposadly there are 75 mph highways in the void that is the northern mid-west.

  • Senior Member
  • Member
  • Member For: 18y 7m 15d
  • Gender: Male
Hey - it must be mid-day Monday there, shouldn't you guys be working instead of perusing the forum. :D :P

You would have to be kidding! Work is a 4 letter word. :blink:

BTW, welcome and enjoy all that is XR6 Turbo.com :spoton:

  • Next stage, to the Pub in 10 seconds
  • Member
  • Member For: 20y 9m 28d
  • Gender: Male
  • Location: Berwick Victoria

Warm welcome to you Telionis and hope you enjoy viewing countless pages of information about the XR6 Turbo. It's great to have some interest from out side of Australia, and I hope one day you will also enjoy the ride behind the wheel with one of these great cars! If you have any questions feel free to ask because most of the members are a friendly bunch.

Cheers,

Rob... :spoton:

  • Im the one and only
  • Donating Members
  • Member For: 20y 5m 3d
  • Gender: Male
  • Location: In my house
Warm welcome to you Telionis and hope you enjoy viewing countless pages of information about the XR6 Turbo. It's great to have some interest from out side of Australia, and I hope one day you will also enjoy the ride behind the wheel with one of these great cars! If you have any questions feel free to ask because most of the members are a friendly bunch.

Cheers,

Rob... :spoton:

Most.Not all :spoton::blink:

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.



×
  • Create New...
'