Fg Injectors

[straughsberry]

You can get 1000cc 6 orrifice milled Bosch EV14's from the US for much less than that. Check out Five-o motorsport.

[Rhino1980]

Rhino,

The Nizpro squirters are about $700 and a straight swap.

Regards,

Benny

Thanks Benny.

You can get 1000cc 6 orrifice milled Bosch EV14's from the US for much less than that. Check out Five-o motorsport.

Thanks mate. Is this what you use in your car? What power are you making? I am aiming for no more than 320kw by the end of my upgrade path, wouldn't 1000cc's be overkill? Sorry I just don't anything about injectors.

Edited 12/11/09 06:41 AM by Rhino1980

[straughsberry]

It would be overkill but You can get non-milled ones at 55lb. They'd be good for 400rwkw. They are a 6 orifice injector which is supposed to be great for atomisation, economy, response etc. I'm using the 1000cc injectors for my 1000+hp build.

Anyone used a Bosch EV14 on any car?

[Rhino1980]

It would be overkill but You can get non-milled ones at 55lb. They'd be good for 400rwkw. They are a 6 orifice injector which is supposed to be great for atomisation, economy, response etc. I'm using the 1000cc injectors for my 1000+hp build.

Anyone used a Bosch EV14 on any car?

Thanks Straughs and good luck with the Kiloton

[straughsberry]

NP. There are always alternatives. I just think that for 72lb injectors, 700 is fairly step, even though they are meant to be a good injector.

BTW, the EV14's are "shorties" so they're 48mm o-ring to o-ring. You'll need to get adapters and they have US-car plugs but you can get tails. No biggy, easily obtainable from the US as well.

My 1000cc injectors, flow matched with all adapters only cost about USD$550 from memory. At the current exchange rate, that is a great buy.