Jump to content

Recommended Posts

  • Into the laaaake
  • Member
  • Member For: 18y 1m
  • Gender: Male
  • Location: Nrth Qld

If you have to cut the old fitting off, how do you get the new fitting on? Or does the pipe just click into place with it?

  • Donating Members
  • Member For: 18y 6d
  • Gender: Male
  • Location: Ballarat

You screw the in fitting into the power steering pump. Than the pipe get pushed into the fitting. I did this last night. But because I am a retarted and cut the pipe it didnt seal.

When cutting the fitting off, cut at the base of the stepped section. This will cut just above the copper clip that holds the fitting in place. The top of the fitting should come off the top. Than you'll need to push the bottom section down. Than remove the copper clip. Now the fitting is off. Check the pipe for damage. Than reinstall the new fitting. Easy as if your not a retard like me.

:blush::beerchug::beerchug:

  • Donating Members
  • Member For: 18y 6d
  • Gender: Male
  • Location: Ballarat

By the looks of it, yeah. I could just patch it up. But I dont wont it to leak again. You'll be right with yours just dont go up and down the fitting. Just cut in along the step section.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'