hey guys I have just purchased a bf tornado with dual climate,

this head unit runs a sub in the sedans so my q is where can I find the low level signal to run a sub in my ute

EG kick panel or under the icc

thank in adfvance

dean

and I want in ipod input with the filter box who on the site should I be able to get one off

hi Dean,

I can help you out with you ipod request

as for the sub out, you can grab the output from the main board of the icc. you do need to be handy with the soldering iron though

if you need more info just ask

more info would be very good

so it looks like I gotta pull the icc out. doh

does anyone know if the sub signal is lp or full and it seems to have a mild subsonic in a mates sedan or is that all in the amp

more info would be very good

←

what would you like to know???

so it looks like I gotta pull the icc out. doh

does anyone know if the sub signal is lp or full and it seems to have a mild subsonic in a mates sedan or is that all in the amp

←

its not hard to pull the ICC out. once you have done it a few times it only takes 5 mins.

pulling it appart takes a little more time because you need to be careful not to dislodge any of the springs in the stacker.

from memory the sub out on the icc is full range and the low pass is done at the amp.

are you looking to run a sub on your factory unit??

if so the best way I have found is to run a line level convertor(stinger is the best) from the rear steakers,

I got 145db from this setup...

Do you have a better picture before you did the wiring. Would be good to have a circle around each point and what the point goes to.

For me it looks like its front and rear left and right youve connected there.

Do you have a better picture before you did the wiring. Would be good to have a circle around each point and what the point goes to.

For me it looks like its front and rear left and right youve connected there.

←

a picture without the wires? I didn't take one but you will get a real life version when you pull your ICC apart

the black wires are all ground, the others are FL, FR, RL, RR, SUB.

you also need to cut the track there on to disengage the ICC amp.

If I get some spare time ill write a how to mod your ICC doc with full instructions.

Edited December 5, 200619 yr by shockF6

That would be awsome. What did you use to cut the track?

Dont know if I got the balls to mod it my self I got better things to spend my money on(Such as making my car faster) than buying an new ICC.

Might get the stereo shop to do it with the instructions.

Howyou you figure all this stuff out?