Jump to content

It's Barra season..


HI PSI

Recommended Posts

  • Member
  • Member For: 17y 10m 3d
  • Gender: Male
  • Location: Central Queensland

A small project that I've started.. 

 

Sonic tested Fg Mk1 block  (Has both BA/F and FG dipstick provisions). Tunnel alignment checked, bearings fitted and clearances measured. Atomic main and head studs (14.3 mm).

 

BDQPx08.jpg

 

Factory crank that has been nitrided and stress relieved. Mains and big ends are 10/10. Rotating components balanced. Acl, 360 degree thrust main bearings and ACL big end set. Crank machined and Torrington thrust bearing installed.

 

 

MmWBfXn.jpg

 

 

3kiPzPY.jpg

 

Atomic 998 conrods, JE ceramic coated pistons, thicker gudgeon pin

 

IYxZujk.jpg

 

An interesting find by my engine guy. Misaligned machining of the gudgeon pin oil feed (slot going left instead of right) . We modified all 6 rods.

 

MvAnfNY.jpg

 

 

That's all that we managed to fit in today. Hopefully more progress tomorrow... Till then, stay safe.

  • Like 7
  • Thanks 2
Link to comment
Share on other sites

  • 1 month later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'