Jump to content

Innovative MTX-L Plus wideband sensor dimming


BigKriss

Recommended Posts

  • Member
  • Member For: 12y 4m
  • Gender: Male
  • Location: Sydney, Australia

G'day guys,

 

I have almost finished installing a wideband oxygen sensor to monitor air/fuel ratios. 

 

Any ideas where I can access a "headlight power wire" to help dim the display at night?

 

 

IMG_20190715_192407.jpg

IMG_20190715_175129.jpg

Link to comment
Share on other sites

  • Member
  • Member For: 12y 4m
  • Gender: Male
  • Location: Sydney, Australia

I have it running now. I didn't connect it to the light power wire.

I have disabled the rear oxygen sensor in the pcm, the one after the catalytic converter.

Is it easy to remove? (Disconnect), I had a look underneath there but I couldn't see where it was connected to??

Link to comment
Share on other sites

  • Member
  • Member For: 12y 4m
  • Gender: Male
  • Location: Sydney, Australia

Thank you for your help.

 

I saw the plug for the oxygen sensor but I couldn't get to it so I just cut it off.

 

The gauge holder was for a BMW E36 but I just put it on to this car.

 

8400b98966d6cac5ece6f702631c5225.jpg2dc7f1272f82e8179d2e71cd237e55b7.jpg

 

I got the long cable version but it's not needed.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'